Millions of jade ring faces are also polished in this way

Jade ring faces have always condensed all the essence of jade, so whether it is the type, water, or color, they are all excellent.

The ring face represents the highest quality of jade, so the craftsmanship must be very complicated. So that’s what I thought!

How are jade ring faces made? After reading the following, you may have a new understanding!

This material belongs to a friend in Jieyang, and it was bought back from Myanmar a few years ago. In the eyes of ordinary people, even if it is given away for free, they would think it is too small and ugly and has no value. However, people who know the business understand that this ugly material is not ordinary!

If you observe it under a light, you will know that this is the leather that "Hui Ka" will produce white fog. The Hui Ka field often produces top-quality small pieces, many of which are heavyweight. This piece of material is smaller than a little finger, and you can vaguely see the translucent meat inside through the skin.

When the clothes of the jadeite raw stone are taken off, a girl wearing silky satin is revealed, which is so heart-warming to see.

After some grinding, the following amazing effect is shown. Perhaps some people will say that too much material is lost, and a piece of material is left with only the size of a soybean. The essence is the best!

It's even more beautiful under natural light!

This is what this ugly material looks like after all of it has been peeled off. Even before the finished product is out, it can be seen that it is valuable. After all, the raw stones were bought at a huge price.

I will use a poorer piece of material to teach you how to grind egg noodles:

The color of this small egg-shaped pearl is good, but it is not too old. Let's see what the effect will be when it is exposed to water.

1

First draw a rough outline based on the material. This is the front side.

Consider various defects and other conditions, determine the scope of grinding, and draw the waistline. Although this step sounds simple, the quality of grinding depends most on this step.

2

The reason why the egg-shaped surface looks so regular and round is that it is also slowly ground out from a regular body.

Diamond sand tray is needed to grind the ring surface

The price is cheap, you can buy it for a few hundred

It is better to grind it into a regular body first and then proceed to the subsequent grinding.

3

Use the emery disc to round the sharp corners of the regular body evenly, so that the error can be controlled to a minimum!

4

Polishing with fine sand and diamond powder can not only correct the less round curvature, but also roughly polish the ring surface.

Now this small ring face is 80% complete, but the surface is still very rough and the effect is hard to see.

Finally, after continuous polishing with sandpaper of smaller mesh size and polishing with diamond paste, the effect gradually emerged!

Just like that, a ring face was made.