Tricolor jadeite raw stone, see how the carving master manipulates the ingenious design to make it lifelike

Speaking of jadeite mining areas, I believe everyone knows the jadeite rough stone from Damakan. This mining area is most likely to produce multi-colored jadeite, the most typical of which is yellow and green. So what do you think of multi-colored jadeite?

Today, the editor saw a piece of Damakan jadeite raw stone. It was very small and had a very thin skin. The owner had peeled it and was preparing to design and carve it. The cut material didn’t look very good, but the color was rich and colorful. There was a large area of ​​eye-catching green on the front, and not only that, there was yellow jade at the upper and lower ends. There was deep white flesh on the back. If you taste it carefully, it really had the artistic conception of tri-color jadeite.

If I were to ask the editor, it would be easy and cost-effective to just put it on a rope and polish it, but the owner doesn't think so. As the saying goes, "jade cannot be made into a useful object without being carved." If it is carved, its value will be even more considerable. Besides, this is green, white and yellow tri-color jadeite, and the quality is also very good. After careful design and carving, you can imagine how valuable it is.

The editor witnessed the entire process of this material from rough stone to uncut jade: first, make full use of the green color on the front to design the lotus leaf. The green color of the lotus leaf is just the most suitable design. The curvature of the lotus leaf and the curling of the edge of the leaf can also be used to remove the cotton wool. The back is going to be hollowed out and carved with two small fish under the lotus. The yellow jade at the bottom can also be designed to be the tail of the fish.

As for the yellow jadeite at the top of this piece of material, the editor feels that the carving master used it most appropriately. The lotus designed below happens to reach the top, and a dragonfly is designed to fly on it, and the dragonfly is designed using yellow jadeite. The overall artistic conception can be stamped with each other without conflict. The whole piece is natural and harmonious, and has a poetic mood!

During the carving process, it is inevitable to find some small flaws on it. The most prominent and difficult ones are a few small cracks. However, there is no rush and they can be salvaged. The small cracks below can be carved into lotus roots and water splashes, and the cracks will be removed.

The carving is complete. The finished product is stunning. The superposition of double colors makes the whole work more layered and has a different charm. Here are some beautiful pictures from various angles.

The finished product can be considered to be carved, and it looks particularly bright and beautiful after polishing. To achieve the finished product effect you see, not only the exquisite carving and unique design themes are needed, but also the magical charm of jade itself. Only then can such a masterpiece be created, which is full of different charm and is refreshing!

fcgc66

fcpf18